DIY bracelet from wire

Original handmade bracelets from wire can be a beautiful accessories for yourself and your loved ones. And it’s not so hard to make it! Here’s 2 ways to create awesome bracelet DIY from wire. Follow them!

In order to make such a bracelet, you will need

 wire

 round pliers

 beads

 connecting rings.

Take a piece of wire and thread it through the bead. One tip is bent with round pliers to prevent the bead from falling out.

From the other end, take the wire, start to twist it, and then wind it on the bead. Make tight turns at the base of the bead.

After you have wrapped a part of a bead, stretch the wire to the opposite edge and wrap around the loops you made earlier. You will get a workpiece for the bracelet. For an adult's wrist, you will need about 7 such blanks.

You need to parse the chain into links and find the same flat rings. After this, take two flat rings and begin to connect them with links.

In addition to this bracelet, you can make a necklace around the neck and earrings. For these decorations, you can buy additional fasteners in the hardware store. 

The second variant of bracelet is even simpler than the previous one. You need to parse the chain into links and find the same flat rings. After this, take two flat rings and begin to connect them with links. Every two rings you need to connect 7-8 links. 

Thus, connect about five large rings. The dimensions of the finished bracelet depend on the size of the rings and links. To fasten the bracelet comfortably, fasten the hook or lock.

Your bracelet is ready! Make it a gift for somebody or enjoy it yourself!